Chevrolet Sonic 2015 Owner's Manual page 27

Hide thumbs Also See for Sonic 2015:
Table of Contents

Advertisement

1-20
In Brief
To turn off both traction control
and StabiliTrak, press and hold
the TCS/StabiliTrak button
until the traction off light
the StabiliTrak OFF light
illuminate.
Press the TCS/StabiliTrak button
again to turn on both systems.
See Traction Control/Electronic
Stability Control on page 9-28.
Tire Pressure Monitor
This vehicle may have a Tire
Pressure Monitor System (TPMS).
The low tire pressure warning light
alerts to a significant loss in
pressure of one of the vehicle's
tires. If the warning light comes on,
stop as soon as possible and inflate
the tires to the recommended
pressure shown on the Tire and
Loading Information label. See
Vehicle Load Limits on page 9-9.
and
The warning light will remain on until
the tire pressure is corrected.
The low tire pressure warning light
may come on in cool weather when
the vehicle is first started, and then
turn off as the vehicle is driven. This
may be an early indicator that the
tire pressures are getting low and
the tires need to be inflated to the
proper pressure.
The TPMS does not replace normal
monthly tire maintenance. Maintain
the correct tire pressures.
See Tire Pressure Monitor System
on page 10-48.
Engine Oil Life System
The engine oil life system calculates
engine oil life based on vehicle use
and displays the
I n f o r ma t i o n P r o v i d e d b y :
message on the DIC when it is
necessary to change the engine oil
and filter.
Remember, the oil life display must
be reset after each oil change. It will
not reset itself.
Resetting the Oil Life System
1. Press the MENU button to show
2. To reset the engine oil life
Be careful not to reset the oil life
display accidentally at any time
other than when the oil has just
:
% CHANGE
been changed. It cannot be reset
accurately until the next oil change.
Remaining Oil Life on the
display. This display shows an
estimate of the oil s remaining
useful life. If 99% is displayed,
that means that 99% of the
current oil life remains.
system, press the SET/CLR
button while the oil life display is
active. After a few seconds,
there will be a single chime and
the oil life will be reset to 100%.

Advertisement

Table of Contents
loading

Table of Contents