Table of Contents
Advertisement
Item
Saturation
Gain
Color mode
4.5.4.2 Display
From Main Menu->Setting->System->Display, you can go to the following interface. See Figure 4-26.
Here you can set menu and video preview effect. All you operation here does not affect the record file and
playback effect.
Now you can set corresponding information.
Note
lack brightness while the bright section may over exposure .The
recommended value ranges from 40 to 60.
It is to adjust monitor window saturation. The value ranges from
0 to 100. The default value is 50.
The larger the number, the strong the color is. This value has
no effect on the general brightness of the whole video. The
video color may become too strong if the value is too high. For
the grey part of the video, the distortion may occur if the white
balance is not accurate. Please note the video may not be
attractive if the value is too low. The recommended value
ranges from 40 to 60.
The gain adjust is to set the gain value. The default value may
vary due to different device models. The smaller the value, the
low the noise. But the brightness is also too low in the dark
environments. It can enhance the video brightness if the value
is high. But the video noise may become too clear.
It includes several modes such as standard, color, bright,
gentle. Select a color mode, the sharpness, brightness,
contrast and etc can automatically switch to corresponding
setup.
Figure 4-26
102
Advertisement
Table of Contents
