Loewe Xelos A 22 Operating Instructions Manual page 16

Modes of operation - EPG
Programming recording for recorders
You prepare the station marked with the
by pressing the red button. In the following menu you confim the
timer data or change them as required. Then a red dot is set in front
of this program in the EPG program list as an identification. If you
want to delete the timer programming, remove the timer entry
in the external recorder.
EPG menu
Call EPG menu
EPG menu
Select provider
You will find the following settings in the EPG menu:
• Select provider • TV on when marked • Data capture
Select provider
You can change the provider (the station which transmits EPG data)
to have other programs evaluated. You can do this under "Select
provider". Call this menu with OK in EPG mode. If the station
you want to change to is not listed in the "Select provider" list, start
the provider search with the green button. This takes a while.
Then a program range search is performed. The programs offered by
the provider are displayed in a list.
TV on when marked
You can have the TV switched on automatically from standby at the
beginning of the memorized program. If you are not present at the
time, a safety prompt makes sure the TV switches off again after 5
minutes.
16
32172_XelosA22_GB
buttons for recording
INFO
TV on when marked Data capture
OK
16
Data capture
After these settings or after every time the mains plug has been
pulled out the data must be collected first. To do this, select the
program which you have defined as a provider and leave it switched
on for about 2 hours or switch the set to standby.
After approx. 2 minutes the display on the appliance
glows orange, and in the display there is the
announcement "EPG DATA". The data capture begins
and lasts about 2 hours. The data are also
automatically collected between 2 and 5 in the
morning when the TV is switched to standby.
END
A prerequisite for data entry is that "Data capture" is "on" in the EPG
menu.
Note:
All EPG data are lost if the mains plug is pulled out.
If you cannot receive any EPG providers, for example, you should
switch off the data entry.
03.05.2005, 9:27 Uhr