Programming The Thermostat; Changing Program Schedules; Copying A Program - Nordyne IQ Drive User Manual

The iQ Drive Thermostat is factory programmed with default schedules based on typical usages.
Modifi cation of the program schedules is not required, but can still be customized to adjust the heating/
cooling system on individual days, a combination of days, weekdays, weekends, every day, or an entire
week. The instructions below do not apply to iQ Zone Systems with zone control enabled. Before the
heating or cooling system can be activated, the thermostat must be placed in an operating mode
(AUTO, HEAT, COOL, or E HEAT). See Page 6 for mode setup instructions.
Other features include a nonprogrammable option that manually controls the heating or cooling equipment
by disabling the usage of all programming schedules, Smart Recovery, and temperature holds. In
nonprogrammable operation, the thermostat requires less user setup. If this option is desired, see page
11 for setup instructions.

Changing Program Schedules

Each day in the PROGRAM MENU contains 2 or
4 customizable schedules (also called events) that
display the TIME an event begins, temperature
setpoints (HEAT and COOL), and FAN setting
(AUTO or ON). The default setting for this thermostat
is 4 Schedule Events/Day, but can be changed by
performing the setup instructions on page 11. The
thermostat requires that the COOL setpoint must
be at least 2° (F) above the HEAT setpoint. This
minimum difference is automatically maintained by
the thermostat. NOTE: Holding the
down for several seconds will adjust some of the
values in larger increments.
1. Select MENU on the
Main Screen using the
or button.
2. Press the button.
3. Select PROGRAM
using the or
button.
4. Press the button.
5. Select an option
from the list in the
PROGRAM MENU
using the or
button.
6. Press the button.
7. See page 10 to
change the time of
an EVENT, the HEAT/
COOL setpoints, or
FAN setting.

PROGRAMMING THE THERMOSTAT

or button

























Copying a program:

The COPY option is displayed at the top of the
PROGRAM MENU and can be used to copy a
schedule from one day to many other days without
having to perform redundant programming of the
thermostat. This feature can be used after a schedule
has been set in one of the days.
1. Select COPY at the
top of the PROGRAM
M E N U u s i n g
or button.
2. Press the button. The
thermostat will display a
list of days to copy from.
3. Select a day in the COPY
FROM list using the
or button.
4. Press the button. The
thermostat will display a
list of days to copy your
program to.
5. Select a day in the COPY
TO list using the
button.
6. Press the button
to save the setting.
NOTE: To schedule
additional days, repeat
steps 3 - 6.



t h e 





















or













9