Digital proportional r/c coaxial helicopter (7 pages)
Summary of Contents for MJX R/C X800
Page 1
ITEM NO.X800 2.4G 6-AXIS 3D ROLL GRAVITY SENSOR R/C Hexacopter With 6-Axis Gyro Technical parameter of the hexacopter Fuselage Length:210mm Gross Weight: about 70.5g Motor: Coreless motor Overall height: 45mm Battery: Li-polymer 3.7V 750mAh Main Rotor Diameter: 55mm Charging Time: about 90 minutes...
This product is not a toy. It is not applicable for children who are under 14 years old. Please read this instruction manual carefully before playing and operate the product according to the manual. The users are in full charge of proper operating the hexacopter. The manufacturer and dealers disclaim all responsibility for the damage caused by misuse.
Page 3
Left control stick Mode 1:Forward/backward,leftward/rightward Mode 2:Forward/backward,turn left/turn right Right control Gravity control mode: press the right remote control stick,there stick will be a beep sound, the remote control code will change from normal control to gravity control. Mode 1: Turn left/turn right fine tuning Trim A Mode 2: Leftward/rightward fine tuning Mode 1: Leftward/rightward fine tuning...
The Hexacopter Major parts of the hexacopter Light Rotor blade ON/OFF Motor Protecting frames Landing gear How to charge the hexacopter Unplug the battery cable from the power wire plug and take out the battery. Insert the USB charger into the USB interface of the computer;...
Page 5
Clockwise Counterclockwise (Motor 1) (Motor 2) Head of the hexacopter Left Right Counterclockwise Clockwise (Motor 6) (Motor 3) Tail of the hexacopter Clockwise Counterclockwise (Motor 5) (Motor 4) Pic.5 Check the rotation direction of the rotor blades which is shown as Pic.5 If the hexacopter keeps flying to one side, it can be corrected by adjusting the trimmer on the remote control.
Page 6
2. If the hexacopter keeps moving leftward/rightward even there is no control signal given, users may adjust trim A or trim B to keep the hexacopter balanced. Mode 1 If the hexacopter keeps moving leftward, press the right button of Trim B until it gains balance. If the hexacopter keeps moving rightward, press the left button of Trim B until it gains balance.
Page 7
Mode 2 If the hexacopter keeps spinning counterclockwise in the air, press the right button of Trim B until it gains balance. If the hexacopter keeps spinning clockwise in the air, press the left button of Trim B until it gains balance. Push up the throttle control stick, the rotation speeds of the mains rotors Upward...
Page 8
Turn the sideward flight control stick Leftward flight to the left side,the hexacopter will fly leftward. Turn the sideward flight control stick Rightward to the right side,the hexacopter will flight fly rightward. 3D Roll There are 3 channels of the remote control: low speed channel, medium speed channel and high speed channel.
Page 9
Gravity control mode 1.Press the right remote control stick,there will be a beep sound, the remote control code will change RC control to Gravity control. When the remote control is leaned forward, the hexacopter will fly forward. When the remote control is leaned backward, the hexacopter will fly backward.
Page 10
#C4005 installation: Pic.11 Pic.12 Pic.13 Pic.14 Pic.15 Pic.16 Pic.17 Pic.18 1.Take out the screws of the battery door by screwing counter-clockwise (Pic 11). 2.Pull out the battery door(Pic.12). 3.The camera should be fastened to the interface at the bottom of the hexacopter.(Pic.13) 4.Fix the camera by screwing clockwise.(Pic.14) 5.Insert the camera wire plug to the camera interface.(Pic.15)
1.Take out the screws of the battery door by screwing counter-clockwise (Pic 19). 2.Pull out the battery door(Pic.20). 3.The camera should be fastened to the interface at the bottom of the hexacopter.(Pic.21) 4.Fix the camera by screwing clockwise.(Pic.22) 5.Insert the camera wire plug to the camera interface.(Pic.23) 6.Insert the camera wire plug to port of C4006.(Pic.24) 7.Insert the antenna bracket into interface of the foot stand and lock the screws.(Pic.25)
Trouble shooting phenomenon reason solution Gyro of the hexacopter is Set the hexacopter to under signal detecting The lights are flashing quickly. any flat surface. condition. For absence of signal, activate the remote The hexacopter is not control for the signal received the signal from the The lights are flashing on twice connection.For signal...
Need help?
Do you have a question about the X800 and is the answer not in the manual?
Questions and answers