Advertisement
Advertisement
Table of Contents
Related Manuals for MJX R/C T10 Shuttle
Summary of Contents for MJX R/C T10 Shuttle
- Page 2 7.4V1100mAh 14:1 The wire that fixed on the landing gear is the receiver of the helicopter, disassembling this wire may be dangerous or causes accident. When the controller/helicopter is underpowered, the control distance would be shortened due to this effect. If the helicopter is underpowered, it would result in difficulty of taking off or lower flight altitude.
- Page 3 Light indicator Power socket split charging device Battery connecting plug Battery charging plug all-in-one charging device To meet the different demands from different customers worldwide, two different charging devices have been designed for charging. One is split charging device (1 piece charger +1 piece charge controller), the other one is all-in-one charging device (one charger only)The product is included with either of the two charging devices.
- Page 4 How to charge the helicopter by split charging device (Pic 3 & 4) Turn off the helicopter; unplug the battery cable from the helicopter. Insert the plug of the battery cable into the quadrate port of the charge controller (matching the plug to the port) Insert the plug of the charger cable into the circular port of the charge controller, then, connect the plug of the charger to AC power outlet to start charging.
- Page 6 the trimmer...
- Page 7 PREPARATION FOR FLIGHT Must set the remote controller to the “OFF” position before operating step 1 1. Turn on the helicopter by inserting the battery plug into the battery socket, the helicopter light will keep quickly blinking for about 3 seconds while the helicopter is checking the middle point of the gyro. Then, the light of the helicopter will blink slowly, indicating that the helicopter is ready to connect with the remote controller.
Need help?
Do you have a question about the T10 Shuttle and is the answer not in the manual?
Questions and answers