Table of Contents
Advertisement
2
LCD Display
3
Zignature Pad frame
Setup the Zignature Pad
1. Place the Zignature Pad in stable area where there is adequate space for
operation
2. Use the attached USB cable to connect the Zignature Pad tablet to the host
computer. USB-B side to the Zignature Pad and USB-A to the rear USB port
on the host computer.
3. Plug the cable attached to the AC adapter into the DC In port on the rear side.
4. Plug the other end of the power adaptor into an AC outlet.
5. The hardware is ready and the Zignature Pad should turn on and display the
default logo (10ZiG logo).
NOTE: Do not connect the USB adapter to the computer until software installation is
complete.
Warning:
Do not connect / disconnect the pen unit while the Zignature Pad is
connected to power.
Quick Start Guide
8
240V
60Hz
Advertisement
Table of Contents
