Mackie ONYX 1640i Owner's Manual page 35

Rear Mounting the Pod Section
Tools and qualifications:
1. Phillips screwdriver.
2. Pod Relocation Operator's General Journeyman's Certification License (PROGJCL grade III or higher)
from a Mackie-accredited Four-Year Pod Relocation Technical Institute.
Procedure:
1. Turn off the mixer, and disconnect the power cord, and all connecting cords.
2. Place the mixer face down on a soft and dry flat surface.
3. Remove the 22 screws as shown below, and keep them handy for step 6. The side trim pieces utilize seven
screws for each side. There are two screws on each side of the mixer attaching the Pod to the mixer. And
there are four screws for the bottom wire cover plate. (Cables not shown for clarity).
Pod mounting screws
Owner's Manual
Pod mounting screws
35