Additional features include:
• OBD II Interface — Connect with the On-Board Diagnostics
(OBD II) connector port on your vehicle to power on your mobile
hotspot. The OBD II connector port is usually located on or under
the dash, on the driver's side. Other possible locations are the
center console area or inside the glove compartment.
• Reset Key — Restore the device to the factory default
configurations.
• Guest Wi-Fi – Set up a guest Wi-Fi network for temporary users, and
use the main network for trusted devices.
2
Install Your Mobile Hotspot
Make sure your vehicle is parked outside in a safe location and the
engine is turned off.
Insert your mobile hotspot into the OBD II connector port (or
into the extension cable if it is required). Ensure that your mobile
hotspot is inserted in the correct direction.
Note: Insert the mobile hotspot carefully to avoid damaging it.
Status LED Indicator
The LED indicates the device's connection status:
Off
Green solid
LED 1
(Power)
Red blinking
Red solid
Off
Red solid
LED 2
Green solid
(Signal)
Red blinking
Green blinking
Sleep mode (Wi-Fi off)
Power on
Factory reset
SIM locked
No network service available
FOTA updating
Connected to mobile network,
Wi-Fi network available
FOTA update failure
FOTA update success
3
Need help?
Do you have a question about the Mobley and is the answer not in the manual?