Asus RS700-E8-RS8 Series User Manual page 110

PCH SATA Configuration
SATA Controller [Enabled]
Allows you to enable or disable the SATA Controller.
Configuration options: [Disabled] [Enabled]
Configure SATA as [AHCI]
Allows you to identify the SATA port is connected to Solid State Drive or Hard Disk Drive.
Configuration options: [IDE] [AHCI] [RAID]
SATA Mode options
SATA LED locate [Enabled]
If enabled, LED/SGPIO hardware is attached.
Configuration options: [Disabled] [Enabled]
Support Aggressive Link Power Management [Enabled]
Allows you to enable or disable the Suport Aggressive Link Power (SALP) Management.
Configuration options: [Disabled] [Enabled]
SATA Port 1~6
Port 1/ Port 2/ Port 3/ Port 4/ Port 5/ Port 6 [Enabled]
Allows you to enable or disable the SATA port
Configuration options: [Disabled] [Enabled]
USB Configuration
xHCI Mode [Auto]
Allows you to enable or disable the mode of operation of xHCI controller.
Configuration options: [Auto] [Disabled] [Enabled]
USB Ports Per-Port Disable Control [Disabled]
Allows you to control each of the USB ports 1 to 8 disabling.
Configuration options: [Disabled] [Enabled]
The following items appears only when the USB Ports Per-Port Disable Control is set to
[Enabled].
USB Port #1/ #2/ #3/ #4/ #5/ #6/ #7/ #8/ #10 [Enabled]
Configuration options: [Disabled] [Enabled]
USB 3.0 Port #1/ #2/ #3/ #4 [Enabled]
Configuration options: [Disabled] [Enabled]
5-34
Chapter 5: BIOS setup