PRESONUS AudioBox 22VSL Owner's Manual page 27

Owner's Manual
High Pass Filter Freq
Gate On/O Button
Gate Threshold
Compressor On/O
Auto Mode Button
Software: Virtual StudioLive and Studio One Artist
Adjust the High Pass Filter's Cuto Frequency.
The High Pass lter's cuto frequency can be set from 18 Hz to 1.3 kHz.
Remember that all frequencies below a high-pass lter's cuto
frequency are attenuated. See Section 5.3.1 for more details.
The slope of the High Pass lter is -6 dB/octave.
The High Pass Filter is accessible from the Main
VSL Page as well as the Gate Zoom.
Turns the Gate On and O for the Selected Channel or Bus.
This button engages and disengages the gate for the selected channel.
It will illuminate to indicate that the gate has been enabled.
The gate is available for all input and output buses.
Sets the Threshold of the Gate for the Selected Channel or Bus.
The Gate Threshold determines the level at which the gate will
open. Essentially, all signals above the threshold setting are passed
through una ected. You can set the threshold from 0 to -84 dB.
The Gate can be controlled either via the
Threshold knob or from the Gate Graph.
Turns the Compressor On and O for the Selected Channel or Bus.
This button engages or disengages the compressor for
the selected channel or output bus. It will illuminate to
indicate that the compressor has been enabled.
The compressor is available for all input and output buses.
Enables Automatic Response Mode.
When Auto mode is active, the Attack and Release controls become
inoperative, and a preprogrammed attack and release curve is used. In
this mode, the attack is set to 10 ms, and the release is set to 150 ms.
All other compressor parameters can still be adjusted manually.
4
Virtual Studio Live 4.1
23 23 23