Conversion Of Pan Bars And Rosette; Conversion Of Video 60 Plus Efp To Include Flat Base; Conversion Of The Video 60 Plus Efp To Include Mitchell Base - Sachtler Video 60 Plus EFP User Manual

Video 60 Plus EFP
Turn the spindle to the right until you can see it coming out
at the front of the head.
Place the fixation screw in the spindles top end and tighten
it. The spindle is now fastened.
The conversion is done.

5.2 Conversion of pan bars and rosette

Open the 4 screws of the pan bar rosette and remove it.
If this is not possible hammer the positioning pins through
to the inside.
Replace the rosette against another one from the Sachtler
accessory range and position it first with the two pins.
Place the 4 allen screws and fasten them hand-tight.
Now you can use other pan bars.

5.3 Conversion of Video 60 Plus EFP to include flat base

Put the Video 60 Plus EFP upside down, so that you can
access the bottom of the head.
Next to the centre bolt you will see 4 allen screws. Those
have to be unscrewed and the whole piece has to be remo-
ved.
Now the Video 60 Plus EFP can be mounted onto flat base
tripods and pedestals with 4 bolt flat base directly. For
Quickfix mount and all Sachtler pedestals the Multi Disc
from the Sachtler accessory range is required.
It is mounted onto the fluid heads 4 bolt flat base.
5.4 Conversion of the Video 60 Plus EFP to include
Mitchell base
Especially in the United States the Mitchell mount is widely
spread.
To convert put the fluid head upside down, so that you can
access the bottom of the head.
- 22 -
Manual