Omega 8500 Owner's Manual page 5

ASSEMBLY
continued)
Position S-Rod upright.
1
Rotate the LOCKING COLLAR fully in the
2
counterclockwise direction.
Insert your finger inside the tube and make sure the
3
INTERNAL CAM LOCK is flush with the inside of the
tube.
S-ROD
S-ROD
5
Insert the MIDDLE STEM into the S-ROD,
4
with the SILVER BUTTON pointed upward.
Rotate the MIDDLE STEM until the SILVER BUTTON
5
locates in the hole.
Twist the LOCKING COLLAR fully in the clockwise
6
direction until it locks.
Repeat this process on the LOWER STEM.
7
Using the BOLT and KNURLED KNOB, attach the
8
SEARCHCOIL to the LOWER STEM.
Adjust the LOWER STEM to a length that lets you maintain
9
a comfortable upright posture, with your arm relaxed at your
side, and the SEARCHCOIL parallel to the ground in front
of you.
Wind the CABLE securely around the STEMS.
10
Connect CABLE PLUG to housing.
11
Do not twist the Cable or Plug. Turn Locking Ring only.
Use minimal finger pressure to start the threads. Do not
cross-thread. When the Locking Ring is fully engaged
over the threaded connector, give it a firm turn to make
sure it is very tight. When the Locking Ring is fully
engaged over the threaded connector, it may not cover all
of the threads.
Tighten both LOCKING COLLARS.
12
*
Note: Very tall users can purchase the optional Extended Lower Stem (TUBE5X), for extended reach.
Caution:
Forcing in MIDDLE STEM with CAM LOCK raised may form a burr on
cam lock. If this happens, remove burr with knife to allow insertion.
2
LOCKING
COLLAR
3
INTERNAL
CAM LOCK
SILVER BUTTON
4
MIDDLE
STEM
MIDDLE STEM
4
5