Sanyo CZP2900TX Instruction Manual page 7

L
Mom /
STEREO v
When receiving stereo sound, the stereo indicator
If this key is pressed, monaural sound is heard,
indicator goes out. Press again
STEREO SOUND
m
STEREO
BILINGUAL 1/11
When receiving bilingual sound,
to stereo sound.
MONAURAL
illuminates.
and stereo
SOUND
El
MONO
*C=**+
yellow
the stereo indicator illuminates.
If this key is pressad, the main or the sub sound is heard, and the
selected sound (1 or 11) is displayed on the screen by green colour,
DIRECT PROGRAMME SELECTION ( The 0-29 programme ) -/--
For selection of programma position 0-9, press the corresponding
button. If the required programme is more than 10, for example 23,
first press "-/--" button and enter 2, then 3,
CHANNEL SELECTION ( The 01-99 channel ) CS
Press the "CS') button once to switch channel selection operation.
Using the O to 9 selection buttons, salect the channel number of
the desired TV station. Example 45, first press "CS" button. enter
4, then 5.
FINE TUNING < >
You can adjust the fine tuning by pressing the fine tuning button
on the R/C transmitter.
OFF TIMER @
Press the off timer button on the R/C transmitter, "-00 - -120"
number is indicated on the top left of tha screen. Repeated
pressing of the button changes the number in 30 minutes staps. For
example, "-90" means that TV is switched off after 90 minutes. Just
one minute before switching off, "-01" and programme number you are
watching, are displayed on the screen.
off timer
-lt-
–<>+
—-+
Ooy
Oay
0000
a
E
D-a I/n
000+
–?+
00+0
Ob&I
m
Right speaker
D"
1
~
Main channel
sound
I
~.d
left speaker (Mono mode)
BILINGUAL SOUND
El
1/11 green
OFF TIMER
El
-90
Note: This TV set incorporates the sleep timer function,
which automatically switches off the TV set and
switches it to the stand-by mode about 10 minutes after a TV broadcast finishes or there is no longer a TV signal.
Thereafter, the TV set will not switch on even if a TV signal is input. To switch the TV set on, uae the main
switch or the ramote control transmitter.
-6-