Set Lock Code - JVC LT-40X776 User Manual

Initial Setup

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
preset with a lock code of "0000". You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
π †
è
The first digit will be highlighted
è
π †
Continue to follow these directions for all four numbers
When a viewer attempts to watch a blocked channel, this message appears:
The channel will remain blocked until the correct lock code is entered (see above for
information on setting your lock code).
Notes:
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
44
Downloaded from www.Manualslib.com
Press the M button
ENU
To SET LOCK CODE
To operate (lock icon appears)
Press Z to access the lock code
ERO
To select the number
To move to the next digit
Press the OK button to finish (your lock code is now set)
Press the Menu button when finished
THIS PROGRAMMING EXCEEDS
YOUR RATING LIMITS.
PLEASE ENTER LOCK CODE BY
10 KEY PAD TO UNLOCK IT.
manuals search engine
SET LOCK CODE
LOCK CODE
SELECT
NO. - - - -
0000
PRESS TO FINISH
OK
OPERATE EXIT
MENU