Step 1 How To Set Up Your Unit; Initial Setup - Feedandgo FEED AND GO User Manual

STEP 1 HOW TO SET UP YOUR UNIT

BACK VIEW
Carefully unpack your Feed and Go device from its packaging.

INITIAL SETUP

1. Ensure that there are no cables plugged into your Feed and Go device.
2. Plug the power cord into the Power Jack (A) located at the back of the unit and insert
the power plug into a wall socket. The Network LED (J) and Cloud LED (K) will flash
a few times and then turn off. When the power is connected, you will see the
power LED glowing.
3. a) If you have Wi-Fi and your Internet router has a WPS function (look for the letters
WPS anywhere on your router) then go ahead to page 8 and follow the instructions
under A. Set up using WPS.
7
J K
A