Panasonic CF-71 Series Reference Manual page 24

Using a Multimedia Pocket Device
Software Preparation (first time only)
The following settings are necessary to prepare the CD-ROM pack for use:
1
2
3
To use the CD-ROM pack in the MS-DOS mode, configure the drive following the steps below
after performing the above steps 1 ~ 3. If the steps listed below are performed without
completing steps 1 ~ 3 above first, the drive will not operate properly.
1
2
3
4
5
6
7
8
9
If the CD-ROM pack has not been accessed within 30 seconds, the drive motor will automatically
shut down to reduce the power consumption. When the CD-ROM pack is accessed once again,
the power of the drive motor is turned on. However, approximately 30 seconds are required until
data is actually read from the CD.
Add the check mark for [DMA] in [Start] - [Settings] - [Control Panel] - [System] - [Device
Manager] - [CDROM] - [MATSHIT A UJDA150] - [Settings].
Set [L:] for both [Start drive letter] and [End drive letter] in [Reserved drive letters].
At the [System Properties], press [Close]. The display will ask you to restart Windows, then
press [Yes].
Using the CD-ROM pack in the MS-DOS mode
Click the [Start] button then select [Shut Down].
Select [Restart in MS-DOS mode] and click [OK].
Open the "CONFIG.SYS" file for editing by issuing the following commands:
cd \ Enter
edit config.sys Enter
Move the cursor to the line containing "ATAPICD.SYS" and delete the characters "rem" at the
beginning of the line. (Deleting "rem" causes the item to become valid.)
DEVICEHIGH=C:\WINDOWS\COMMAND\ATAPICD.SYS /D:MSCD000
(If this line is missing, add it.)
Press Alt + F , then S
the Edit program.
Follow the same steps to edit the "AUTOEXEC.BAT" file.
edit autoexec.bat Enter
Move the cursor to the line containing "MSCDEX.EXE" and delete the characters "rem" at the
beginning of the line. (Deleting "rem" causes the item to become valid.)
LOADHIGH C:\WINDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
Press Alt + F , then S
the Edit program.
Restart the computer.
Power-saving mode
NOTE
[Removable Disk (A:)] is displayed in [My Computer], but access is not possible. Select
[Cancel].
If the vibration of the CD-ROM drive is excessive, set the [CD-ROM Drive Speed] to [Low] in
the Setup Utility.
to save the file. Then press
to save the file. Then press
Alt + F , then X to exit
Alt + F , then X to exit
24