Regulatory Notices - NETGEAR Fuse User Manual

Do not open, disassemble, puncture, crush, bend, or shred.
n
Do not expose to water or other liquids, fire, explosion, or other hazards.
n
Use the battery only in the NETGEAR Fuse Mobile Hotspot.
n
If using with a charger, use only the AC charger supplied with your device.
n
Do not short circuit the battery.
n
When replacing a battery, use the same model of battery that was supplied with your device.
n
Follow local regulations when disposing of a used battery.
n
Avoid dropping your device or the battery. If dropped and you suspect damage, take it to a
n
service center for inspection.
Note: I mproper battery use may result in a fire, explosion, or other hazard.

Regulatory Notices

This section contains regulatory information for your device.
The design of the NETGEAR Fuse Mobile Hotspot complies with U.S. Federal Communications
Commission (FCC) guidelines respecting safety levels of radio frequency (RF) exposure for mobile
devices, which in turn are consistent with the following safety standards previously set by U.S. and
international standards bodies:
ANSI / IEEE C95.1-1999, IEEE Standard for Safety Levels with Respect to Human
n
Exposure to Radio Frequency Electromagnetic Fields, 3kHz to 300 GHz
National Council on Radiation Protection and Measurements (NCRP) Report 86, 1986,
n
Biological Effects and Exposure Criteria for Radio Frequency Electromagnetic Fields
International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998, Guidelines for
n
limiting exposure to time-varying electric, magnetic, and electromagnetic fields (up to
300 GHz)
FCC ID: PY3AC778S
RF Exposure - The NETGEAR Fuse Mobile Hotspot has been tested for compliance with FCC RF
exposure limits in a portable configuration. At least 1.0 cm of separation distance between the
NETGEAR Fuse Mobile Hotspot and the user's body must be maintained at all times. This device
must not be used with any other antenna or transmitter that has not been approved to operate in
conjunction with this device.
WARNING (EMI) - United States FCC Information - This equipment has been tested and found
to comply with the limits for a Class B computing device peripheral, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
Safety Information 108