QOLSYS QS-1311-P01IQ PINpad Installation Manual

QS-1311-P01 IQ PINpad™
Features
• Secure, 4-digit Code to disarm
• 1-button arming
• Red/Green LED arming feedback
• Small, yet comfortable keypad
• Mounts on wall via VHB® tape, or screws
• Secure for carrying in purse or mounting on car visor
• Strong, reliable RF signal.
• 4-6 year battery life on CR2032 battery.
Key Instructions
•
Enroll as a Key Fob.
• Code programming
Default access code is "1234".
To change access code: Do these steps within 4 seconds
1. Enter current 4-digit access code.
2. Press and hold the "1" and "3" keys simultaneously.
seconds, Red LED will be lit)
3. Enter new 4-digit access code.
(the Green LED will be lit)
Note new access code . BAD GUY CANNOT RESET CODE.
So it must be recorded and remembered!
• Enrolling:
1. Refer to the Qolsys control unit installation manual.
2. Put the control panel in RF Learning mode.
• Press both the Stay & Away buttons simultaneously for 3
seconds.
Operation
PINpad
Panel Action
Button
Stay ARM STAY
Away ARM AWAY
PIN Code DISARM
Stay + Away PANIC ALARM
Page 1 of 3
QS-1311-P01_Qolsys IQ PINpad.doc
www.ResolutionProducts.com
POWERED BY
(after 3
LED
flashes double red
flashes double red twice
flashes double green
flashes red 8 times
17-Sep-13
Pictures
TO CHANGE PIN CODE:
Current 4-digit access code, and then...
1 + 3 simultaneously
and then...
Enter New Code
Red/Green
Status LED
Shows command sent
Stay + Away
Panic (Enroll)
Battery Replacement
Insert Screwdriver
here
to open
Page 2 of 3
QS-1311-P01_Qolsys IQ PINpad.doc
www.ResolutionProducts.com
Red LED,
=
CR2032 Battery
+ Terminal up
17-Sep-13