Table of Contents
Advertisement
REVERSING THE DOOR SWING
Ensure the Freezer is unplugged and empty.
We recommend you have someone to assist you.
Tools required
Phillips style screwdriver
Flat bladed screwdriver
Small adjustable spanner
Before you start lay the Freezer on its back in order
to gain access to the base. You should rest it on
soft foam packaging or similar material to avoid
damaging the cooling pipes at the rear of the Freezer.
4
Stand the Freezer, use a flat bladed screw driver to
remove the 2 screw covers at the rear of the Freezer
lid.
8
Remove the three screws and the plastic blanking
plate and replace them on the opposite side of the
cabinet.
1
Remove both adjustable feet and remove the bottom
hinge bracket by unscrewing the bolts. Support the
door to avoid damage.
5
Unscrew and lift the lid of the Freezer from the rear
and remove it. Put it in a safe place.
9
Refit the top bracket fitting the hinge pin, spacers
and washers into the bushing at the top of the door.
Check the door is aligned correctly before tightening.
2
Remove levelling foot from this point and relocate it
into available point at opposite front corner.
6
X
Remove the top hinge bracket by unscrewing the
three retaining nuts. DO NOT undo the nut holding
the hinge pin. Support the door to avoid damage.
10
Replace the lid by fitting the front first and sliding
into place, securing it with the two screws. Replace
the screw covers.
3
Unscrew and remove the hinge pin and refit it into the
adjacent hole . Refit the bracket fitting the hinge
pin, spacers and washers into the bushing at the
bottom of the door. Replace both adjustable feet.
7
Unscrew and remove the top hinge pin, turn the
bracket over and replace it. Tighten securely.
Check that door is
11
aligned horizontally
and vertically. Re-
adjust the levelling feet. See
'Levelling the Freezer' on
page
2.
6
Advertisement
Table of Contents
