907-0601-00 Rev. C
6.2
907-PC104 (907 to Standard PC/104 Adaptor)
Card P/N
Config. Dwg.
Model 907 cards use a proprietary PC/104-connector pin designation for backplane communication and
power. If a system requires the Model 907 stack to be directly connected to a standard PC/104 stack, the
907-PC/104 Adaptor board must be used to prevent damage. This card provides isolation between the
PC/104 backplane and the Focal 907 stack. Only the +5 V pins and the GND pins are connected through the
PC/104 connector. Figure 6-3 shows the 907-PC104 adaptor board.
Recommended practice, however, is to power the Model 907 card stack separately from any standard PC/104
stack.
Focal Technologies Corp.
907-0205-00
907-2010-00
Figure 6-3: 907-PC104, 907 to Standard PC/104 Adaptor
Model 907 Video/Data Multiplexer – User's Guide
J1 MODIFICATIONS
REMOVE PINS A1 - A29
B14 - B19
C2 - C19
D2, D3, D11-18
1
D
C
A
B
1
20
32
Page 6-3