SAFELERT Setup Guide
POWERED BY
Before You Begin,
You Will Need
Your Liberty SAFELERT Sensor and the
included AA batteries.
A computer, smartphone or tablet with
Wi-Fi capability.
A flat-head screwdriver.
Your wireless (Wi-Fi) network name and
password. To make the setup easier, write
them in the space below:
Network Name: __________________________
Password: ________________________________
1
Install the batteries into your
SAFELERT Sensor, and wait for the
LED light to turn solid RED.
A slot on the left side of the SAFELERT Sensor enables
you to pry the case open using a flathead screwdriver.
2
Press and hold the little, white button
on the front of your SAFELERT Sensor
until the LED light flashes YELLOW.
You may need to hold the button down for
up to 15 seconds. The LED may blink other
colors before it begins flashing YELLOW.
Tip
3
When the LED light on your SAFELERT
Sensor is flashing YELLOW it is in a
special setup mode. You can connect
to it just like you would your home or business
Wi-Fi network.
Tip
Wi-Fi
Ensure that Wi-Fi is enabled on your computer,
smartphone or tablet, then continue.
4
Go to the wireless (Wi-Fi) settings of
your computer, smartphone or tablet.
Search for available wireless networks
and connect to the Wi-Fi network named Elertus.
Wi-Fi
Wi-Fi
The Elertus Wi-Fi network cannot provide an
internet connection, but will provide access to
the SAFELERT setup web page.
5
Open an internet browser on your
computer, smartphone or tablet.
It may show you an error indicating that
you do not have an internet connection.
This is normal.
Tip
In the address bar type: 10.5.5.2 and press
Enter or Go.
Wi-Fi
6
Your browser will now load a special
SAFELERT Setup Web Page.
Follow the onscreen instructions to
complete your SAFELERT Sensor setup.
Setup
page
Need help?
Do you have a question about the SAFELERT and is the answer not in the manual?
Questions and answers