Linksys Wireless-G Business Ethernet Bridge WET200 Product Data page 2

Features
• 5 port 10/100 Base-T
Ethernet Managed Switch,
Autosensing half/full duplex
& MDI/MDI-X
• Supports 802.11b and
802.11g wireless connection
to Access Point
• Easy installation and
configuration Web Interface
• Supports WEP, WPA-PSK,
WPA2-PSK, WPA-ENT, WPA2-
ENT wireless encryption
• Supports 802.1X, EAP-TLS,
PEAP authentication with
Radius server
• SMA detachable Dipole
antennas with 1x2 MIMO to
increase coverage
• Supports Power over
Ethernet (PoE) or external
DC power
• Supports SNMP and
intuitive Web-based
interface
• Support 802.1Q and port-
based VLAN on LAN switch
- 1 VLAN bridged over
wireless
• Support 802.1p, IP TOS, and
DSCP based QoS on LAN
switch, WMM on wireless Tx
• Support Rate Limiting on
both wired switch and
wireless interface
• Support Spanning Tree
protocol, port mirroring, and
MAC-based ACL
• 3 year limited warranty
PRODUCT DATA
BUSINESS SERIES
Wireless-G Business Ethernet Bridge
Specifications
Model WET200
Standards IEEE802.11g, IEEE802.11b, IEEE802.3, IEEE802.3u, IEEE802.3af (Power
Over Ethernet), 802.1p (QoS priority), 802.1Q (VLAN), 802.1X (Security
Authentication), 802.11i - Ready (Security WPA2), 802.11e - Ready (Wireless QoS)
Ports 5x 10/100 Base-T Ethernet, 12 VDC Power
Buttons Reset
Cabling Type UTP CAT 5
LEDs Power, POE, Wireless, Ethernet 1-5
Operating System Linux
Setup/Config
WebUI Built in Web UI for Easy browser-based configuration (HTTP/HTTPS)
Management
SNMP Version SNMP Version 1, 2c, 3
Web F/W upgrade Firmware Upgradable Through Web-Browser
DHCP DHCP Client
Operating Modes
Wireless Client Infrastructure or Ad-Hoc
Wireless
Spec/Modulation Radio and Modulation Type: 802.11b/DSSS, 11g/OFDM
Channels Operating Channels: 11 North America, 13 Most of Europe (ETSI and Japan)
# of Internal Ant. None
# of External Ant. 2 (Omni-Directional) SMA detachable
Transmit Power Transmit Power (Adjustable) @ Normal Temp Range:
11b: 12 ± 1 dBm; 11g: 16 ± 1 dBm
Antenna Gain in dBi 2
Receiver Sensitivity 11g: 54Mbps@ -69dBm, 11b: 11Mbps@ -82dBm
Security
WEP/WPA/WPA2 WEP 64bit/128bit, WPA-PSK, WPA2-PSK, WPA-ENT, WPA2-ENT
Access Control MAC-Based ACL between wired and wireless interfaces
802.1X IEEE 802.1X support
Quality of Service
QoS 4 queues
Queue mapping on ingress based on default priority, 802.1p tag, DSCP & IP ToS
Rate limiting on both ingress and egress direction
General
16 VLAN groups
256 MAC address entries across wireless bridge
1024 MAC address entries in the switch
Environmental
Dimensions 6.69" x 8.07" x 7.68" (170 x 205 x 195 mm)
Weight 12.17 oz (345 g)
Power 12V 0.5A DC input, and IEEE802.3af Compliant PoE
Max. power draw: 4.2 Watt
Certification FCC, ICES-003, CE
Operating Temp. 32ºF to 104ºF (0ºC to 40ºC)
Storage Temp. -4ºF to 158ºF (-20ºC to 70ºC)
Operating Humidity 10% to 85% Non-Condensing
Storage Humidity 5% to 90% Non-Condensing