IT IS THE OWNERS’ RESPONSIBILITY TO ESTABLISH THE DATE OF PURCHASE BY ACCEPTABLE EVIDENCE AT TIME SERVICE IS SOUGHT. 2. Any unit, which in the judgment of OWI INC, is defective or develops defects under normal use will be replaced or repaired without cost within the warranty period.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. - This OWI product should be situated so that its location or position does not interfere with its proper ventilation. For example, the component should not be situated on a bed, sofa, rug, or similar surface that may block any ventilation openings, or placed in a built-in installation such as a bookcase or cabinet that may impede the flow of air through ventilation openings.
Page 5
18. OWI recommends that this apparatus be placed on a switched power outlet, one that switches both sides and has contact separation of at least 3 millimeters.
OWI User Manual: Model AMP-BT-602-1 Speaker Amplifier Introduction The OWI AMP-BT-602-1 is a self powered speaker/amplifier. This unit can drive up to four speakers connected series parallel to have a net impedance of 8 ohms. With an included UL Listed, Level 5 (Energy Star), 15 volt, 3.5 ampere power supply, the amplifier can output 40 watts, or 10 watts per speaker in a four speaker hook-up.
OWI User Manual: Model AMP-BT-602-1 Speaker Amplifier SPECIFICATIONS (AMP-BT-602-1) BLUETOOTH SPECIFICATIONS AMP-BT-602-1 Certified SIG Bluetooth Version 3.0 Frequency Range 2.40 – 2.48 MHz Supports A2DP, AVRCP, HFP/HSP and SPP Password Protected ELECTRICAL AMPLIFIER AMP-BT-602-1 Input voltage, nominal (25 watts) 15 volts DC Input current, opera ting (15VDC) 1.667 amperes peak...
Page 8
OWI User Manual: Model AMP-BT-602-1 Speaker Amplifier NON-AMPLIFIED SPEAKER P602 6.5" Passive Cabinet Speaker DESCRIPTION: OUTDOOR: 4Ω IMPEDANCE: 86 dB SENSITIVITY (1W/1M): DISPERSION: 92° MAX POWER (8 Ohms): 30 W 15 W NOMINAL POWER (8 Ohms): 80 Hz - 20 kHz...
OWI User Manual: Model AMP-BT-602-1 Speaker Amplifier AMP-BT-602-1 TO ANOTHER AMP-BT-602-1 SPEAKER WIRING SINGLE LINE DIAGRAM Chained Self Amplified Speakers Wiring OWI INC. www.owi-inc.com...
Open the device Bluetooth manager and review its list of discoverable Bluetooth devices. The speaker amp will appear as OWI-XXXX where XXXX is the last 4 digits of the speaker amp MAC address. Note: The speaker amp MAC address is identified on a label located on the speaker amp board.
However, we will pay the return shipping charges to any destination within the U.S.A. if the repairs are covered by the warranty. 3. Any unit which in the judgment of OWI Inc. is defective or develops defects under normal use will be replaced or repaired without cost within the warranty period.
OWI User Manual: Model AMP-BT-602-1 Speaker Amplifier Established 1978 OWI Incorporated 17141Kingsview Ave. Carson CA 90746-1207 USA Tel. 310-515-1900 Fax 310-515-1606 www.owi-inc.com 02/04/15 OWI INC. www.owi-inc.com...
Need help?
Do you have a question about the AMP-BT-602-1 and is the answer not in the manual?
Questions and answers