2. In the command prompt, enter ipconfig /all. Then press the Enter key.
3. Write down the Physical Address as shown on your computer screen; it is
the MAC address for your Ethernet adapter. This will appear as a series of
letters and numbers.
The MAC address/Physical Address is what you will use for MAC Address
Cloning.
Note: The MAC address is also called the Physical
Address.
The example in Figure G-5 shows the IP address of your Ethernet adapter
as 192.168.1.100. Your computer may show something different.
124
Instant Broadband
Figure G-5
Series
EtherFast
®
When entering information for MAC Address Cloning, type the 12-digit MAC
address (see Figure G-6).
Cable/DSL Firewall Router with 4-Port Switch/VPN Endpoint
®
Figure G-6
125