D&K Minikote Owner's Manual page 8

Standard Presets (H) Standard Presets (H)
The Laminator is equipped with 2 factory presets. The buttons are labeled 275 and 225. These buttons
will set both a speed and temperature, that being (275°F and 3 feet per minute) and (225°F and 3 feet per
minute). If one of the presets is engaged, it's corresponding LED will be illuminated.
Motor (I,J,K,L) Motor (I,J,K,L)
The motor controls are the 4 buttons on the right side of the control panel. The "Start" button will start the
motor which will run at the current speed setting. The "Speed Up" and "Speed Down" buttons will adjust
the speed setting. Pressing and releasing the button once will increment the speed by 0.1 ft/min (0.1
meters/min). To rapidly increase or decrease the speed, press and hold the corresponding button. To
stop the motor, press and release the "Stop/Reverse" button. To reverse the machine, press and hold the
"Stop/Reverse" button. The motor will remain in reverse as long as the button is depressed.
User Preset (M) User Preset (M)
The The Laminator is equipped with a user de ned "Preset" button. This button can be used to save a speed
and temperature setting that you have de ned. With the machine's speed and temperature set to your
preferred settings, press and hold the "Preset" button until the beeper sounds and the preset light comes
on. To recall this setting at a later time, press and release the "Preset" button.
Usage Counter (N) Usage Counter (N)
The Laminator is equipped with a usage counter that will indicate the feet (meters) of lm used. This coun-
ter will appear on the display whenever the feet indicator light is on. This counter can be reset to zero by
pressing the "Count Reset" button once the display is showing the usage counter.
Additional Features Additional Features
Keyswitch Keyswitch
The keyswitch (located just below the control panel) locks out the motor, allowing the machine to remain
heated; yet, preventing unauthorized usage when in the locked position.
6
Laminator.com www.laminator.com