Yamaha Reface CS Owner's Manual page 53

Issue
Certain sounds
stopped being
produced after
operating a con-
troller.
Only one note can
be played at any
Certain
time.
sounds are
not produced.
Sound out-
Low notes are not
put is inter-
produced.
mittent and
stuttered.
The instrument
stopped produc-
ing organ sounds.
(Only percussion
can be heard.)
Changing a set-
Sounds con-
ting caused
tinue without
sounds to con-
end.
tinue without end.
Sounds are distorted.
A pedal has no effect.
Model(s) Suspected cause
The maximum number of
sounds that can be pro-
CS
duced by the Phrase
DX
Looper has been
exceeded.
CS The playing mode has been
DX set to "MONO."
Only the [16'] FOOTAGE
slider is lowered, and the
[OCTAVE] slider is also
YC
lowered. In this condition,
notes are too low to be pro-
duced.
With the H-type organ, low-
ering the [1'] FOOTAGE
slider does not cause organ
YC
sounds to be produced.
Instead, it produces only
percussion sounds.
The Release (R) setting
CS from the EG section is too
high.
CS The delay's depth is set too
DX high.
CS The Phrase Looper is play-
DX ing a loop phrase.
The depth for D.DELAY or
CP
A.DELAY is set too high.
Parameters used to distort
All
the sound have been set.
The pedal is not correctly
All
connected.
Solution
Use the instrument in such a
way that the maximum num-
ber of simultaneous sounds is
not exceeded.
Switch the playing mode from
"MONO" to "POLY" to play
multiple notes at the same
time.
Raise the [OCTAVE] slider.
This is normal.
Lower the [R] slider from the
EG section.
Lower the delay depth.
Pause or stop the Phrase
Looper.
Lower the D.DELAY or
A.DELAY depth.
On the reface CS, change the
OSC, resonance, or distortion
effect settings; on the reface
DX, change modulator values
or distortion effect settings; on
the reface CP, change the
[DRIVE] knob setting; on the
reface YC, change the DIST
setting.
Ensure that the pedal's cord is
fully plugged into the [FOOT
CONTROLLER] or [SUSTAIN]
jack.
reface CS/DX/CP/YC Owner's Manual
Appendix
47