Table of Contents
Advertisement
When the coolant stops draining,
6.
tighten the drain plug at the
bottom of the radiator. Put a new
washer on the drain bolt, then
reinstall the drain bolt in the
engine block. Tighten it securely.
Tightening torque:
61 lbf·ft (83 N·m , 8.5 kgf·m)
7.
Remove the engine cover.
CAP
BLEEDER BOLT
Loosen the bleeder bolt on top of
8.
the engine.
9.
Pour Honda All Season
Antifreeze/Coolant Type 2 into
the radiator. This coolant is a
mixture of 50 percent anti-freeze
and 50 percent water. Pre-mixing
is not required.
The cooling system capacity is:
0.61 US gal (2.3 )
Cooling System
10.
Tighten the bleeder bolt when
coolant comes out in a steady
stream with no bubbles.
Install the radiator cap, and
tighten it fully.
CONTINUED
Maintenance
175
Advertisement
Chapters
Table of Contents
