Advertisement
(OPTIONAL) MOUNTING INSTRUCTIONS
The Xclaim Access Point can be mounted to a wall, ceiling or
to a T-bar using the supplied mounting screws or the T-bar
clips built into the bottom of the Access Point enclosure.
Mounting to a Flat Surface
1
Use this Quick Start Guide template(background
image in this page) to mark the locations for screw
holes on the mounting surface. Use a 5mm drill bit to
drill approximately 25mm into the mounting surface.
2
Insert the anchors and mounting screws into the
mounting surface, leaving approximately 1/4" (6
mm) of the screw heads protruding for the Access
Point enclosure. The screws should be
approximately 3.25" (82.6mm) apart per the
template.
3
Insert the unit removal pin into the hole on the side
of the AP.
&
W >
4
Place the Access Point onto the mounting screws
so that the screw heads enter the mounting holes
on the Access Point enclosure, and push the
Access Point (to the left or down depending on
orientation) to lock in place.
5
Remove the unit removal pin to release the lock
mechanism and secure the Access Point.
6
To unmount, insert the unit removal pin into the hole
on the side of the Access Point to unlock, then push
the Access Point (to the right or up, depending on
orientation) to release the Access Point enclosure
from the mounting screws.
Copyright © 2015 Ruckus Wireless, Inc.
Published May 2015
Mounting to a T-Bar
1
Orient the Access Point so that the T-bar is
positioned between the T- bar clips as shown in
&
W
Figure 2,
then rotate the Access Point until the third T-bar clip
catches the T-bar and the latch locks the T-bar in
place (Figure 3).
&
W
&
^
2
For added physical security, use a Torx
screwdriver to insert the security screw into the
hole shown in Figure 3.
3
To remove the unit, first remove the security screw,
and then depress the latch while rotating the Access
Point so that the T-bar clips disengage the T-bar.
FOR MORE INFORMATION
For information on Xclaim Access Points, visit
http://www.xclaimwireless.com.
W
W
Advertisement
