Welcome! Thank you for your purchase of Listenor Pro, a versatile high quality Assistive Listening Device which enhances the clarity of sound in a variety of everyday situations made by Conversor Limited. Listenor Pro is not sold, advertised, or intended for use as a personal hearing aid.
Listenor Pro overview Socket for ON/OFF button earphones, in the centre headphones or inductive loop Tone control Microphone buttons Socket for audio cable Neck Lanyard directional hook/strap eyelet microphone Volume control buttons Top view Belt clip locating tongue Belt/lapel clip Belt clip grooves.
Safety information CAUTION! Hearing Safety This product is designed to amplify sounds to a high volume level which could potentially cause hearing damage if used improperly. To protect your hearing and the hearing of others: • Make sure the volume is turned down before putting on the earphone or headphone before adjusting the volume to a comfortable level.
2. Open the battery compartment using your thumb to apply pressure to the ribs on the battery door and slide it down and away from the Listenor Pro. 3. Insert two disposable AAA batteries into the battery compartment being careful to place them with the correct orientation of positive(+) and negative(-) terminals.
The high and low settings are indicated by a double beep sound. 10. To switch off Listenor Pro hold down the middle of the control button FIRMLY for about two seconds until the lights on the raised portion of the button start to flash in a circular motion.
You can place the Listenor Pro on the table in a restaurant, group situation or meeting. Placing on the table with the belt clip attached will also raise the microphone to point at the speaker or speakers. When out walking the Listenor Pro can be worn using the belt clip, which can also be used as a lapel or pocket clip, or attached to a skirt.
TV Screens. Consult your audiologist for advice on adjusting or replacing the telecoil for optimum use to minimise the external interference. If you do not Listenor Pro will only serve to amplify this interference.
Attaching the belt clip The belt clip slides into the grooves on the back of Listenor Pro and locks into place under the tongue next to the microphone. It can also be used as a lapel or pocket clip. See the diagram on page 4.
Page 11
1. Directional microphone Where there is a lot of background noise, Listenor Pro can be used with a directional microphone for focussing on the sound of the speaker. The directional microphone will cut out much of the interfering noise improving the quality and clarity of the listening experience.
Page 12
Connect the phono plugs to the TV and the jack plug to Listenor Pro. Adjust the volume on Listenor Pro to optimise your listening experience. This cable does not...
It is available for quick and easy use and Listenor Pro can be used by holding it in your hand and pointing towards the direction of the speaker or sound source, or by just wearing it around your neck.
Feed the cord through the eyelet at the bottom of Listenor Pro and thread the connector through the cord and pull tight. Reconnect the neck lanyard/strap and it is ready to use. See the diagrams below. Care instructions •...
Limited. Contact details are on our website at www.conversorproducts.com or email Conversor Limited at info@conversorproducts.com. Troubleshooting Listenor Pro has been designed for ease of use. However, if you do have trouble, check the following: 1. Make sure the headphones, earphones or...
Manufacturer’s warranty The manufacturer, Conversor Limited, issues a two-year limited warranty to the original consumer of this product. This warranty will go into effect upon the date of original purchase of this equipment, and shall remain in effect for two calendar years from that date.
Page 17
• Consequential damages and damages resulting from delay or loss of this unit. The exclusive remedy under this warranty is strictly limited to repair or replacement as herein provided. • Products damaged in transit unless investigated by the shipper and returned to the warrantor with the investigation report.
Statements of compliance & conformity Listenor Pro is intended to be used as an Assistive Listening Device by persons who are hard of hearing. For sale in the following countries: European Union and all countries outside the European Union Conversor Limited of The Lansbury Estate...
Page 19
IC-Industry Canada Operation of this device is subject to the following two conditions(1)This device may not cause interference.(2) this device must accept any interference, including interference that may cause undesired operation of the device. *For the European Union and EEA only This symbol indicates that this product is not to be disposed of with your household waste, according to the WEEE Directive (2002/96/EC) and your...
Page 20
Contact Details: Made in the UK for Conversor Limited info@conversorproducts.com www.conversorproducts.com...
Need help?
Do you have a question about the Listenor Pro and is the answer not in the manual?
Questions and answers