Linksys EG0801SK User Manual page 21

5. Highlight the Linksys EG1032/EG1064 Instant Gigabit Network Adapter
entry in the window that appears. Click OK.
6. Windows NT then asks you for the media type. Choose the AutoSense
option. When finished, click on OK. Click Close.
7. NT will probably ask you to supply your original Windows NT CD-ROM or
setup disks. Direct Windows NT to the proper location (most likely
D:\i386).
35
Instant Gigabit Series
EtherFast ® 10/100/1000 8+1 Workgroup GigaSwitch Starter Kit
8. Click on the Protocols tab. Add any protocols you require by clicking the
Add button. (Refer to your Microsoft documentation if you have any ques-
tions on adding protocols.)
9. After your bindings, settings, and services are set, click the Close button.
10. Remove your Driver Disk and CD-ROM and click Yes to restart your PC.
11. Once your PC has rebooted, double-click the Network Neighborhood icon
on your desktop. Ensure that you have access to the network. If you do,
your card has been properly installed.
• If you had previously installed a NT service pack, you must re-install that
now. Otherwise, you may receive Not Enough Service Storage Space errors
in the Event Viewer.
• If you need to install the TCP/IP protocol, refer to your system administra-
tor or your Windows NT documentation. Linksys does not provide techni-
cal support for the configuration or troubleshooting of the TCP/IP proto-
col
The Windows NT Installation and Setup of the Instant Gigabit Network
Adapter is complete
N N o o t t e e : If you had previously installed an
NT service pack, you must reinstalll it
now.Otherwise, you may receive Not
Enough Service Storage Space errors
in the Event Viewer.
36