Table of Contents
Advertisement
Installing the Instant Gigabi
Installing the Instant Gigabit Network Adapter if
Networking is Already Installed
Networking is Already Installed
The following steps will install the Instant Gigabit Network Adapter's driver
software on your PC, enabling your PC to properly communicate with the card.
Remember that you must be logged on as a network administrator (or as a
user with administrative rights) to continue.
1. Click on Start, Settings, Control Panel, then double-click on the Network
icon.
2. When the networking window appears, choose the Adapters tab. Click the
Add button.
33
Instant Gigabit Series
M
Network Adapter if
EtherFast
®
10/100/1000 8+1 Workgroup GigaSwitch Starter Kit
3. When the list of available network adapters appears, click the Have Disk but-
ton.
N N o o t t e e : : If you install the T T C C P P / / I I P P p p r r o o t t o o c c o o l l , refer to your system admin-
istrator or your Windows NT documentation when installation steps
that aren't listed in this User Guide appear. Linksys does not provide
technical support for the configuration or troubleshooting of the
TCP/IP protocol.
4. Put the Instant Gigabit Network Adapter disk into drive A. Type a:\ into the
box on your screen and click OK.
34
Advertisement
Table of Contents
