COMPRO VideoMate Vista E500F Startup Manual page 8

5. Connect the black socket of Power
Up patch cable to the power switch
connector on the mainboard.
Double check your work. If you plug the cables into the incorrect pins, your
PC may not start or otherwise function improperly.
Connect the white end of the Power Up patch cable to the TV tuner card and
the black end to the mainboard.
Power Up Scheduling is not required for using VideoMate E500F/E500F
PCI-E card. If you don't want to use Power Up Scheduling from the Windows
Shut down state, you can skip the power switch circuit connections, in other
words, you can skip Power Up Connections in steps 3 through 6. You can still
use scheduled recording from Standby mode or powered on state.
7. Insert VideoMate Vista E500F PCIe card in an open PCIe slot.
This completes the hardware installation. Please read the following notes and
proceed to install the software.
8
6. Connect the white socket of Power Up
patch cable to the connector named "JS2"
on the VideoMate Vista E500F PCIe
Tuner card.
Note