Table of Contents
Advertisement
POWERFACTOR SERIES • TECHNICAL SPECIFICATIONS
GENERAL SPECIFICATIONS
CONTROLS
INDICATORS
CONNECTORS
POWER SUPPLY
MAINS CABLE
DIMENSIONS
WEIGHT
ATTENTION
POWERFACTOR 3
1 XLR-F + 1 XLR-M in parallel for each channel
INPUT
OUTPUT
Europe
U.S.
Power requirement
The "Soft Start Circuit" is a device that allows to avoid
high energy consumption when the unit is switched
SSC
on.
The "Active Power Factor Correction" circuit, parts of
the switching supply circuit, simulates a pure resistive
load on the mains line, this permits to ensure almost
total stabilization of the supply voltage of the output
APFC
stage, obtaining a perfect dynamic capacity on PA
systems without over-dimension the power supply of
the mains line.
Supplied with the unit and terminated with a Neutrik
Powercon (type NAC3FCA) at unit side, the other side
(mains line) must be equipped with a right plug at
least 20A current capacity and respecting the
following connections:
Blue wire = N - Neutral
Brown wire = L - Line
Green/Yellow =
These amplifiers cannot be used in bridge mode, this is due to the
PWM final stage structure.
POWERFACTOR 5
ON/OFF switch
Input level control for each channel
SIGNAL LEVEL: 2 x 10-LED bar
PROTECT: 2 red LEDs
HI-FREQ: 2 yellow LEDs
SIGNAL: 2 green LEDs
ON/READY: 1 green LED
TEMP: 1 red LED
1 4-way SPEAKON for each channel
230Vac ±15%
115Vac ±15%
2000W
3400W
- Earth / Ground
483x44x450 mm (WxHxD)
9.5 kg
POWERFACTOR 7
4800W
7 7 7 7 7 ❏ ❏ ❏ ❏ ❏
Advertisement
Table of Contents
