Brod & Taylor FP-201 Instructions Manual

Folding proofer
Hide thumbs Also See for FP-201:

Advertisement

Folding Proofer
Instructions
Model FP-201
www.brodandtaylor.com
For your safety, read this instruction manual before using product.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FP-201 and is the answer not in the manual?

Questions and answers

Summary of Contents for Brod & Taylor FP-201

  • Page 1 Folding Proofer Instructions Model FP-201 www.brodandtaylor.com For your safety, read this instruction manual before using product.
  • Page 2: Important Safeguards

    IMPORTANT 15. Do not store any materials, other than manufacturer’s recommended SAFEGUARDS accessories, in the Proofer when not in use. 16. This appliance is not intended for When using electrical appliances, basic use by persons (including children) with safety precautions should always be reduced physical, sensory or mental followed including the following: capabilities, or lack of experience and...
  • Page 3 NOTICE This appliance is for household use only. Use on Alternate Current (50/60 Hertz) only with voltage as indicated on the manufacturer type plate. Do not attempt to modify the plug in any way. USE WITH AC INVERTERS Exercise caution when using this appliance with DC to AC inverters.
  • Page 4: Control Panel

    NOTE: The display may be configured to display in °F or °C. To switch between modes, press and hold both the “UP” button and the “DOWN” button for two seconds. Features 1. Lid 2. Expanding box section Control Panel 3. Base 4.
  • Page 5: Operation

    GENERAL OPERATING INSTRUCTIONS Set Up Open the lid by lifting the front edge of the Proofer. Allow the lid to rest in a vertical position. Remove the wire rack and water tray. Lift the expanding box section from the front edge, allowing it to remain attached to the base at the back so it can pivot open.
  • Page 6: Cleaning And User Maintenance

    The HEATING light will illuminate indicating that the heat plate is warming up. When the Proofer reaches its temperature set point the HEATING light will go off. It is normal for the HEATING light to flash on and off as the Proofer maintains its temperature during use. Select Celsius or Fahrenheit The display on the control panel indicates the temperature set point.
  • Page 7 FP-201 Dimensions: Inside box (open): 37.5 cm x 32 cm x 20 cm high Outside body (open): 46 cm x 37 cm x 27 cm high Outside body (closed): 46 cm x 37 cm x 6.5 cm high Temperature Range: 21 - 49C Maximum capacity: Two “large”...
  • Page 8 FAQ (Frequently Asked Questions) Can I run my Proofer for more than a few hours at a time? Yes, the Proofer is durable and may be run continuously. It uses very little electricity, only about 30 watts per hour when set at 24C. Is there one temperature that works well for rising all types of bread? The temperature we find ourselves setting over and over again is 27C.
  • Page 9 small metal cup (about 250ml or less) half full with room temperature water and place on the wire rack in the center of the Proofer. Set the Proofer to 29C. Wait 60 minutes and then measure the temperature of the water. The water temperature should be within 1-2 degrees of the set point.
  • Page 10 Berkshire Innovations, LLC P.O. Box 712 Copyright 2010-14 Williamstown, MA 01267 All Rights Reserved. (413) 458-9933 Rev.0314.1 www.brodandtaylor.com...

Table of Contents