Neck Support - Vela Hip Hop 300 User Manual

14

1.5.3.6 neCk support

The neck support is adjusted by loosening the screws.
1.5.3.7 arM rest
The height as well as the width of the arm rests can be adjusted.
The height is adjusted by loosening the screw with the accompanying
key. Remember to tighten it well again. The width is adjusted under
the seat in the accessory groove by loosening the two screws and
adjusting the metal rail, which holds the arm rest. Remember to
tighten the screws with the accompanying tool.
1.5.3.8 pushInG yoke
The height of the pushing yoke can be adjusted by loosening the
lever. Remember to tighten it well afterwards.
1.5.3.9 foot support
The foot support, which is standard equipment on the VELA Hip
Hop 300 series, can be removed. The height of the foot plate can
be adjusted by loosening the lever, which is behind the foot plate.
Remember to tighten the lever again.
1.5.4 aCCessorIes
As a standard, the accessories are already fitted when delivered.
1.5.4.1 re-fIttInG of aCCessorIes:
• Side supports
Sidesupport shall be placed on the armrest.
Loosen the screw on the outside of the armrest. Remove the inside
plastic cover by removing the four screws.
Place the side supports on the inside of the armrest, and tightened
the screw on the outside of the armrest again.
• Braces and vest & Thigh restraints
The two grooves are re-fitted on each side of the base of the seat.
Re-fit the grooves using the following accessories:
1.5.4.2 foot and ankLe restraInts
These are re-fitted by placing the tape through the holes in the
foot plate.
1.5.4.3 Body supports
Body supports are fixed to the back-rest like the neck support.
1.5.4.4 knee restraInts
Knee restraints are fitted by screwing them onto the fixture on the seat.
1.5.4.5 taBLe
The table is fixed onto the fixture on the armrest.