Neck Support; Arm Rests - Vela Hip Hop 300 User Manual

1.4.3.4 neCk support

The neck support is adjusted by loosening the wing screws.
Remember to tighten them again.

1.4.3.5 arM rests

The height as well as the width of the arm rests can be adjusted.
The height is adjusted by loosening the screw with the
accompanying key. Remember to tighten them well again.
The width is set under the seat in the accessory groove by loosening
the two screws and adjusting the metal rail which holds the arm rest.
Remember to tighten the screws again with the accompanying tool.
1.4.4 seat
1.4.4.1 seat depth
The depth of the seat can be adjusted with the help of the
control levers placed under the rear edge of the seat, on the right
side as well as on the left. Both levers must be loosened in order
to adjust the placement of the back-rest. Remember to tighten the
lever afterwards.
1.4.5 aCCessorIe
As a standard, accessories are already fitted when delivered.
1.4.5.1 re-fIttInG of aCCessorIes:
• Side supports
• Braces and vest
• Thigh restraints
The two grooves can be re-fitted on each side of the base of the
seat. The grooves are fitted using the following accessories:
1.4.5.2 foot and ankLe restraInts
These are re-fitted by placing the tape through the holes in the
foot plate.
10