Battery Management - Aetes 700 VA VH Series User Manual

4.6 Battery management

Maximum battery life and reliability are obtained by the following features:
Quick battery test
• • • •
The quick battery test checks whether the batteries and their wiring are healthy. If a quick battery test
shows that the batteries are close to being worn out, a 'replace battery' alarm will be generated (see
4.4.8). The batteries must be replaced as soon as possible (see 7.4).
Automatic battery test
The VH Series UPS conducts periodic automatic battery tests:
• 5 hours after manual switch-on
• 5 hours after return of mains following any power failure, and
• 30 days from the last battery test
Manual battery test
A quick battery test can be initiated manually
- either via the front panel, by pressing pushbutton 'I' for 5 seconds during normal operation,
- or via UPS monitoring software. For details please refer to the manual of your software.
NOTE
If the test is started manually immediately after installation or after a power failure, the
UPS may generate a false 'replace battery' alarm as the batteries have been (partly)
discharged during transport/storage or during the power failure.
Deep battery test
• • • •
A deep battery test, to be initiated through the UPS software via the USB communication port, checks
the actual battery capacity in order to ensure accurate runtime prediction. During a deep battery test
the batteries will be discharged until 'battery low' alarm level. Please note that immediately after a
deep battery test the expected runtime is very short: allow the UPS to recharge its batteries. For
details please refer to the manual of your UPS software.
Temperature compensated battery charging
• • • •
This feature adjusts the battery charge voltage according to the ambient temperature. As a result poor
charging of the batteries under low temperature conditions and overcharging of the batteries under
high temperature conditions are avoided.
Load dependent battery-end-voltage
• • • •
The allowable final battery voltage depends on the discharge current: the higher the current, the lower
the 'end-of-discharge' battery voltage. In this way maximum battery capacity is obtained without over-
discharging. Over-discharging would result in shortened service life and failure to recover normal
capacity.
Automatic boost charge
• • • •
This feature reduces the battery recharge time considerably: totally depleted batteries will be
recharged to 90% in approx. 1.5 hours, provided that discharging took place at 100% load.