Constant Modes; Privacy Mute Mode; Do-Not-Disturb Mode - Linear M&S DMC-10DS Installation And Operation Instructions Manual

Structured wire intercom system
Table of Contents

Advertisement

Constant Modes

Four special constant modes are available for room stations and patio
stations. Each room and patio station can be set to one of the four
modes. Constant modes remain in effect, even after the intercom is
used for other functions. The constant modes can be used to (1) prevent
monitoring from other stations; (2) prevent monitoring and calling from
other stations; (3) monitor sounds in other rooms or audio from an
external source; or (4) select specifi c room stations or patio stations for
constant monitoring.

Privacy Mute Mode

For privacy, room and patio stations
can be set to prevent monitoring
from other stations (if the mute
feature is enabled for the station on
the hub).
To enter or exit Privacy Mute Mode,
momentarily press the station's
MUTE button. In Privacy Mute Mode
the station's MUTE button lights.
The station can still perform regular
intercom communications while in
Privacy Mute Mode.

Do-not-disturb Mode

For privacy and silence, room and
patio stations can be set to prevent
monitoring and calling from other
stations (if the mute feature is
enabled for the station on the hub).
To select Do-not-disturb Mode, press
and hold the station's MUTE button
for two seconds. In Do-not-disturb
Mode the station's MUTE and VOL
buttons light. To exit Do-not-disturb
Mode, press the MUTE button.
The station can still perform regular
intercom communications if the
call is made from the station in
Do-not-Disturb Mode.
14
TO SELECT PRIVACY MUTE
MODE FOR THE STATION,
PRESS THE MUTE BUTTON
WHILE THE STATION IS IDLE
WHEN THE STATION IS IN
PRIVACY MUTE MODE, THE
MUTE BUTTON WILL STAY LIT
OTHER STATIONS WILL
NOT BE ABLE TO MONITOR
THIS STATION WHEN IT IS
IN PRIVACY MUTE MODE
TO EXIT PRIVACY MUTE
MODE, PRESS THE MUTE
BUTTON AGAIN
Figure 27. Privacy Mute Mode
TO SELECT DO-NOT-DISTURB
MODE FOR THE STATION,
PRESS THE MUTE BUTTON
FOR TWO SECONDS
WHEN THE STATION IS IN
DO-NOT-DISTURB MODE, THE
MUTE AND VOL BUTTONS
WILL STAY LIT
OTHER STATIONS WILL
NOT BE ABLE TO MONITOR
OR CALL THIS STATION WHEN
IT IS IN DO-NOT-DISTURB MODE
TO EXIT DO-NOT-DISTURB
MODE, PRESS THE MUTE
BUTTON AGAIN
Figure 28. Do-not-disturb Mode

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dmc-10hDmc-10psDmc-10rsDmc-10

Table of Contents