Table of Contents
Advertisement
Cabling Management - Gabinets & Racks - Rack Accessories - KVM - LP-RU07KVXX Series KVM with 4, 8 and 16 Port
Single Stage Installation
To set up your installation, do the following:
Plug your USB / PS/2 keyboard, USB / PS/2 mouse and monitor into the console port
1
section located on the unit's rear panel.
Using a KVM cable set, plug the DB 15 connector into any available CPU port on the
2
switch.
At the other end of the cable, plug the keyboard, mouse, video cables into their
3
respective ports on the computer.
Plug the power adapter cable into the switch's power jack, then plug the power
4
adapter into an AC power source.
5
Repeat step 2-4 for any other computers you are connecting up.
This completes the single stage installation, and you can turn on the power to the computers.
NOTE:
The
LCD
KVM
switch
initially links to computer
connected to the first
CPU port.
To set up cascade installation, do the following:
1
Set up single installation as mentioned in SINGLE STAGE INSTALLATION.
Connect one end of HDB15 cable to IN port of upper KVM, and the other end to OUT
2
port of lower KVM.
This completes the cascade installation, and you can turn on the power to the computers.
NOTE:
The LCD KVM switch initially links to computer connected to the first CPU port.
PS2/USB Capable Switch with 15, 17 or 19 inch LCD Monitor. User Manual.
Cascade Installation
12
Figure 20
www.lanpro.com
Advertisement
Table of Contents
