Table of Contents
Advertisement
Secondary Entrapment Protection Sensors
Emergency Stop Button
An emergency stop button that is accessible
from the outside of the operator is a
requirement for compliance with UL 325
Safety Standards. The red emergency stop
button is located inside a hole cutout on the
Kinetic cover.
Pressing the emergency stop button while
the gate is opening or closing disables the
automatic close timer and stops gate travel.
The gate travel remains stopped until the
operator receives an open or close signal.
Make sure all users of the gate know where
the emergency stop button is located.
A screwdriver or hex key can be used to
press lightly on the switch to activate it.
Emergency Release
Make sure and teach all users how to turn off electric power and how to move the gate manually. Kinetic
allows a gate to be pushed manually when the operator's DC power is turned off. (You DO NOT need to turn
AC power off to manually push the gate.) See NOTE.
When you turn the DC power off, the following occurs:
•
The motor disengages which makes it easier to push the gate open.
•
The GATE NO LOAD (FAULT 4) appears on the display.
•
The position sensor is active and established limits are remembered.
To turn DC power on, take the following steps:
1. Make sure the gate is not moving.
2. Flip the DC power switch on.
3. Clear any faults by pressing the STOP or RESET.
NOTE
If you turn OFF both power switches (AC and DC) and manually move the gate, the operator
will search for the target to re-establish its limits. When you turn AC & DC power back ON,
the operator will cycle the gate and search for the target magnet (its "home" position).
An operator with the DC power switch ON and the AC power switch OFF still functions
normally, but "NO AC" flashes in the display. If you "push" the gate, it will push back because
the position sensor is active and the motor is engaged.
S-8
Rev: A
Advertisement
Chapters
Table of Contents
