Table of Contents
Advertisement
5. Reinstall the housing and cover.
Car Finder
Press the button twice within
three seconds. The horn will
sound and the turn signals will
E138623
flash. We recommend you use this method
to locate your vehicle, rather than using
the panic alarm.
Sounding a Panic Alarm
Note: The panic alarm will only operate
when the ignition is off.
Press the button to activate the
alarm. Press the button again or
switch the ignition on to
E138624
deactivate.
Remote Start
(If Equipped)
WARNING
To avoid exhaust fumes, do not use
remote start if your vehicle is parked
indoors or areas that are not well
ventilated.
Note: Do not use remote start if your vehicle
is low on fuel.
The remote start button is on the
transmitter.
E138625
This feature allows you to start your
vehicle from outside the vehicle. The
transmitter has an extended operating
range.
Vehicles with automatic climate control
can be configured to operate when the
vehicle is remote started. See Climate
Control (page 110). A manual climate
control system will run at the setting it was
set to when you switched the vehicle off.
Fusion (CC7) , enUSA
Keys and Remote Controls
I n f o r ma t i o n P r o v i d e d b y :
Many states and provinces have
restrictions for the use of remote start.
Check your local and state or provincial
laws for specific requirements regarding
remote start systems.
The remote start system will not work if:
•
the ignition is on
•
the alarm system triggered
•
you disable the feature
•
the hood is open
•
the transmission is not in P
•
the vehicle battery voltage is too low
•
the service engine soon light is on.
Remote Control Feedback
An LED on the remote control provides
status feedback of remote start or stop
commands.
LED
Solid green
Solid red
Blinking red
Blinking green
Remote Starting the Vehicle
Note: You must press each button within
three seconds of each other. Your vehicle
will not remote start if you do not follow this
sequence.
48
Status
Remote start or
extension
successful
Remote stop
successful; engine
off
Remote start or
stop failed
Waiting for status
update
Advertisement
Table of Contents
Troubleshooting
