Touch Control Panel Assembly - Electrolux EI30MH55GSA Service Manual

The touch control section consists of the following units
as shown in the touch control panel circuit.
() Key Unit
(2) Control Unit (The Control unit consists of LSI Unit and
Power U nit)
The principal functions of these units and the signals com-
municated among them are explained below.
Key Unit
The key unit is composed of a matrix, signals generated
in the LSI are sent to the key unit through P20, P2, P22,
P23, P24, P25, P26 and P27.
When a key pad is touched, a signal is completed through
the key unit and passed back to the LSI through P43, P44,
P45 and P46 to perform the function that was requested.
Control Unit
Control unit consists of LSI, power source circuit, syn-
chronizing signal circuit, reset circuit, buzzer circuit, relay
circuit indicator circuit, back light circuit and humidity sen-
sor circuit.
1) LSI
This LSI controls the key strobe signal, relay driving
signal for oven function and indicator signal.
2) Power Source Circuit
This circuit generates voltages necessary for the control
unit from the AC line voltage.
In addition, the synchronizing signal is available in order
to compose a basic standard time in the clock circuit.
Symbol Voltage
VC -5.0V

TOUCH CONTROL PANEL ASSEMBLY

OUTLINE OF TOUCH CONTROL PANEL
Application
LSI(IC)
3) Synchronizing Signal Circuit
The power source synchronizing signal is available in
order to compose a basic standard time in the clock
circuit. It incorporates a very small error because it works
on commercial frequency.
4) Reset Circuit
A circuit to generate a signals which resetting the LSI to
the initial state when power is applied.
5) Buzzer Circuit
The buzzer is responds to signals from the LSI to emit
audible sounds (key touch sound and completion
sound).
6) Stop Switch
A switch to inform the LSI if the door is open or closed.
7) Relay Circuit
To drive the inverter unit, fan motor, stirrer motor, hood
motor, and light the oven lamp and hood lamp.
8) Indicator Circuit
This circuit consists of 25 segments and 4 common
electrodes using a Light Crystal Display.
9) Back Light Circuit
A circuit to drive the back light (Light emitting diodes
LD-LD5).
10) Humidity Sensor Circuit
This circuit detects moisture of the cooking food to allow
its automatic cooking.
11) Inverter Unit Control Circuit
This is the circuit to control inverter unit.
25
EI30MH55GSA
EI30MH55GBA
EI30MH55GWA