Troubleshooting - Sea & Sea YS-D2 Instruction Manual

Troubleshooting

Please confirm the following items. If conditions do not improve even after
the following has been confirmed, please contact the World Customer
Service Center or an authorized SEA&SEA dealer.
READY/TTL lamp does not light up
Do you insert the batteries? (P.E-17)
Do you insert the batteries the right way? (P.E-17)
Did you make sure not to use any old batteries? (P.E-17)
Has the battery cap been closed properly? (P.E-17)
An internal protective circuit is activated if the product begins emitting light
continuously. If this occurs, turn off the power supply, and put a product in a
cool place for a while.
An internal protective circuit is activated if the product is left in an area with
high temperature. If this occurs, put the product in a cool place for a while.
If the product emits the FULL emission of light in more than 20 continuous
bursts, an internal protective circuit will be activated to prevent the reflector in
the strobe from overheating, and the strobe will be placed in standby mode
(with the READY/TTL lamp lights out) for at least 20 seconds. If this occurs,
allow this product to cool naturally for at least ten minutes.
The target light does not turn on
Was the target light button held down for the proper length of time? The target
light may not turn on if the switch is held down for too short a time. Press and
hold down the target light switch for one second. (P.E-13)
Using the Sync Cord
The strobe does not fire
Is the sync cord connected properly? (P.E-19)
Is there any rust on the metal pins of the connector? If there is any rust or
damage found, please contact the World Customer Service Center or an
authorized SEA&SEA dealer.
Using the Fiber-optic Cable
The strobe does not fire
Is the fiber-optic cable connected properly? (P.E-21)
Does the built-in flash/main strobe on the camera fire? (P.E-24)
When there is a sync cord present, fiber-optic connection is disabled even if
there is a fiber-optic cable connected to the unit. To use the strobe with the
fiber-optic cable connection, remove the sync cord. (P.E-19)
E-31