Ys Mount Strobe Adaptor/Ball Mount Strobe Adaptor - Sea & Sea YS-D2 Instruction Manual

Identification of Parts
YS Mount Strobe Adaptor / Ball Mount Strobe Adaptor
A YS Mount Strobe Adaptor is included with this product as standard
equipment. You can change the orientation for the inserted fixing bolt by
changing the orientation for attachment of the YS Mount Strobe Adaptor.
By replacing it with the included Ball Mount Strobe Adaptor, you can select a
method for attachment to a housing that matches the shooting conditions.
How to detach a YS Mount Strobe Adaptor
1
Remove the two cap bolts used to
secure the YS Mount Strobe Adaptor
using the included hexagon wrench
turned counter-clockwise
How to attach a Ball Mount Strobe Adaptor
1
Attach the Ball Mount Strobe Adaptor
to the camera and lightly secure it using
the two cap bolts turned clockwise
by hand.
Use the cap bolts screwed into the YS
Mount Strobe Adaptor.
2
Use the included hexagon wrench to
firmly tighten the cap bolts and secure
the adaptor to the unit.
Use the short end (as shown in the diagram
at right) of the hexagon wrench to tighten
cap bolts.
Do not apply excessive force where
tightening up the cap bolt.
E-15
YS Mount Strobe Adaptor
M4 Hexagon Wrench
cap bolt
M4 Hexagon Wrench
cap bolt
Ball Mount
Strobe
Adaptor