Drayton 22083 Quick Start Manual

TO ADJUST THE TIMES AND TEMPERATURES FOR 7-DAY OPERATION:
6. With the product operating as normal
in the "Auto" mode, press once
and then press the button until the
display is flashing and shows.
7. Press the once, the display will
be as shown. The time will be flashing,
use the or buttons to adjust the
1st time as required.
8. Once time has been set, press
and use the or buttons to adjust
required temperature. Repeat the
above steps 7-8 until the 6 periods
have been set for Monday.
9. Once Monday has been set, press
once. Repeat steps 7-8 until all 7 days
of the week have been set.
10. Once the final temperature has been
set press the to confirm settings.
To exit press or until you
return to auto mode with the bottom
arrow pointing at Auto.
Congratulations!
The unit is now set correctly to follow your required timings.
Invensys Controls Europe
Customer Service Tel: 0845 130 5522
Customer Service Fax: 0845 130 0622
Technical Helpline Tel: 0845 130 7722
Website: www.draytoncontrols.co.uk
Email: customer.care@invensys.com
Quick Commissioning Guide 06490122001 IssA
(* small 1 in lower half of screen shows which time
period is being set e.g. 1=1st period,
2 = 2nd period etc)
Drayton
Digistat +3 / +3RF

QUICK START GUIDE

Drayton Digistat +3 and +3RF
The Digistat +3/+3RF thermostat is a programmable thermostat with 5-2 Day or 7 day
timings and 6 time/temperature events during the day.

Clock Setting

Your Digistat +3/+3RF is fitted with a "real-time clock", which is "pre-set" at the factory;
you will not have to alter the time settings. A special feature of this real-time clock is it
will automatically change over during the GMT/BST summer/winter change over removing
the need to manually alter the clock.

General Operation

Programmable thermostats do not have "On" and "Off" times like traditional timers.
They offer temperature control both day and night and you simply select which
temperatures you require at which times of the day.
With the unit in "Auto-Mode" (the small arrow to bottom of screen will point to Auto) the
temperature can be changed for a short time by using the
temperature in this way will keep the Digistat +3/+3RF set to your new temperature until
the next pre-programmed event (at which time it will revert to programmed temperature).
The temperature you are setting will flash on the screen. Once temperature is set, the
unit will revert to showing the room temperature. The
screen if the heating is calling for heat.
Programmable Room Thermostat
5-2 Day / 7 Day
Models: 22083, 22087 / RF701, 22092
or buttons. Changing the
indicator will show on the