Table of Contents
Advertisement
Cautions on Use of this Product
- Be sure to read this information -
l Cautions on use
Do not subject the camera to impact.
• This camera is a precision machine. Take great care that you do not strike
it against a hard object or let it fall.
Do not point directly at the sun.
• If direct sunlight strikes the lens, the camera could malfunction or a fire
could occur.
No sand or dust!
• If sand or dust gets inside the camera or the AC adapter, it may cause
damage and/or malfunction.
Heat on surface of product
• The surfaces of the camera and AC adapter will be slightly warm, but this
does not indicate a fault.
Be careful of ambient temperature.
• If the temperature of this camera is too high or too low, normal image
output may not be possible.
Be careful of moisture condensation.
• When you move the camera between places where the difference in
temperatures is great condensation (vapor in air warmed or cooled to water
droplets) could occur on the lens and/or inside the camera. If condensation
occurs on the lens, wipe it off with a soft, dry cloth. Even if the external
surface of camera has dried, condensation may remain inside. Therefore,
turn the camera off and leave it in a dry place for at least 1–2 hours before
using it again.
Do not use the camera near strong radio waves or magnetism.
• If the camera is used near strong radio waves or magnetism, such as a
radio wave tower or electric appliances, noise may be present in the picture
and the camera may not operate normally.
At worst the camera could malfunction.
4
Advertisement
Table of Contents
