General Safety - Ecotec Access Operating Instructions Manual

The charger may only be used for the specified battery types
This battery charger is supplied with pre-set charging curves
that are adapted for the battery types listed in figure 1.
Always contact the battery manufacturer to verify that the
charging curve is appropriate.
Hydrogen gas is generated when charging batteries, which
can cause an explosion.
During and immediately after charging, batteries may not be
placed in the vicinity of sparks or open flame.
Do not use the battery charger if it is damaged. Do not
touch damaged components. Turn off the input AC voltage
immediately and contact service personnel.
The battery charger has high voltage inside the charger case
that can cause personal injury or death. The metal casing
may only be opened by authorized service personnel.
Disconnect the battery and input AC power before carrying
out maintenance or cleaning the battery charger.
The Battery charger must be connected to an earth
grounded AC input source.
Batteries should only be charged in a well ventilated area.
`

General Safety

Page 3
.