Advertisement
I
EIectrkal
connection
Electrical ground is required on
this appliance.
Do Not connect
to electrical
supply
until appliance
is permanently
grounded.
See Figure 3.
Electrical Shock Hazard
l
Disconnect
power to Me
junction box.
l
This appliance
must be
connected
to a grounded,
permanent
wiring system or a
grounding
connector
should
be connected
to the
grounding
terminal
or wire
lead
on the appliance.
Failure to do so could rerun in
electrical
shock,
serious
injury,
or death.
This appliance
ls manufactured
with
white neutral supply wire and a
cablnet-connected,
green,
grounding wire twisted together.
Connect
the appliance
cable to the
junction box through the U.L.-listed
conduit connector.
Complete
electrical
connection
according
to
local codes and ordinances.
A. Where local codes permlt
connecttng
the cablnetqroundlng
cmduclor
to the neulrd
Whtte)
juncllon
box We:
Cable
horn
k
I
Figure 1
Gable
horn
rmge
1. Connect
together
3 wires: green
ond white appliance
cable wires
and the neutral white wire in the
junction box.
2. Connect
the two black wires, then
the two red wires. See Figure 1,
B. Where local codes DO
NOT permit
connecting
the cabinet-grounding
conductor
to the neuird
(white)
junctlon
box wire:
Cable
from
JUrlCllOn
power supply
box
\
I
I
1. Separate the green and white
aaollance
cable wires.
2: Connect
the white appliance
cable wire to the neutral (white) wire
in Junction box.
3. Connect
the two black wires, then
the two red wires. See Figure 2.
4. Connect
the green groundlng
wire
to a grounded
wire in the
No. 4
Wh.
5. A separate
copper
grounding
wire
(No. IS minimum)
MUST be
connected
to-a grounded
cold
water pipe by means of a clamp
and then to the external grounding
connector
screw.
DO NOT ground
to
a gas supply
pipe
of hot water
plpe.
C. If connecting
to a
four-wire, electrlcal
system:
DO NOT connect
the cabtnet-
grounding
conductor
to the neutral
(white).
junction
box wire.
k
s
\
cmd"'t
so"necto,
horn
range
Figure 4
I. Separate
the green and white
appliance
cable wires.
2. Connect
the whlte appliance
cable wire to the neutral (white) wire
in the junction box.
3. Connect
the two black wires. then
the two red wires. See Figure 4.
4. Connect
the green grounding
wire
to the grounding
wire in the Junction
box.
Now Start...
With range In kitchen.
1
Remove shipping materiib.
l
tape and protective
film from
zA
~mNtio;ernove
me shIppIng
2
Remove racks and other parts
m from Inside oven. Remove alr
grille taped to top or side of range
3
/
n
Selbcleanhg models:
Remove
screws on each side of the Inner
panel of the oven door. Insert a nail
or a 5/X?' dlameter
item In the hole
In each of the hinges.
Close
door OS
far os possible.
Ltft oven
door
Off of the hlnQeS
and
set OSMe.
Non-setf-cleaning
models:
Open
door to broil 'stop'
position and ltft
door upwards to remove.
Figure 2
Panel
5
Advertisement
