1. INTRODUCTION Congratulations on the purchase of a high quality SportsArt product, the P771/P773 Cable Cross Over/Cable Tower machine. Constructed of high quality materials and designed for years of reliable performance, this product was made for full commercial use. Before this product is assembled or operated, we recommend that you familiarize yourself with this manual.
2. SAFETY PRECAUTIONS This product was designed and built for optimum safety. However certain precautions apply during the use of this product. Please note the following safety precautions: Please read the entire manual before assembly and operation. Make sure the product is installed and operated as instructed in this manual.
Page 6
Assembly Parts (P773) Name Qty. Name Qty. Weight stack frame (With rear support) Components in the Hardware Kit (P773) Name Qty. Specification Notes Double open-end wrench (13*17) Assembly Parts (P771) Name Qty. Name Qty. Weight stack frame Connecting bracket (for P771)
4. ASSEMBLE THE PRODUCT Follow instructions below to assemble this product. Note that in this manual the words “left” and “right” are used to refer to the product and its parts. As such, these designations correspond to the “left” and “right” sides of a person in position to exercise on this product.
STEP 2 Cable Tension Adjustment Instructions 1. If the cable is too tight or too loose, first loosen nut A as shown then adjust nut B. If the belt length is too long, adjust downward; if the belt length is too short, adjust upward. Adjust the belt to the proper position, then tighten nut A to secure the belt length.
5. MAINTENANCE This section covers maintenance topics and includes a maintenance schedule, task list, and log. MAINTENANCE Cable Tension Adjustment Instructions 1. Please apply lubricant to the guide rods every week as follows. (a). Put some lubricant on a clean, lint-free cloth. Rub the lubricated cloth on the guide rods.
MAINTENANCE Important Safety Information 1. Once the machine cable reaches the warranty period, it is recommended to replace the cable. 2. Cable safety check, after a year in use, check cable weekly. Depend on the use conditions, increase the frequency of inspections. (As shown: (A) a cable, (B) the cable extension) During inspection, if you find cracks in the cable is exposed to other unusual circumstances, please immediately stop using the machine and replace the cable.
MAINTENANCE Schedule Area Week Month Quarter Year Notes Exterior Clean. ● Inspect for looseness and secure if Screws ● necessary. To confirm that the machine is Testing ● working properly. Check for damage or wear. If so, need Cable ● for replacement.
MAINTENANCE Task List Like cars, fitness products require maintenance. Regular maintenance extends product life, and failure to maintain products can void the manufacturer’s warranty. Copy the maintenance log sheet, and record maintenance work for each fitness product. Daily tasks 1. Use a clean, lint-free towel to wipe down the product exterior. 2.
6. CONSIGNES DE SÉ SECURITÉ IMPORTANTES Le produit SportsArt a été conçu et fabriqué afin d’assurer une sécurité optimale. Cependant certaines précautions s’appliquent chaque fois que vous utilisez votre produit. Lisez entièrement le manuel avant l’assemblage et l’utilisation. Veuillez aussi noter les consignes de sécurité...
Page 15
6. CONSIGNES DE SÉ SECURITÉ IMPORTANTES (Cont.) ATTENTION Si vous ressentez une douleur ou si vous avez une sensation anormale, ARRÊTEZ VOTRE ENTRAÎNEMENT et consultez immédiatement votre médecin. Entraînez-vous à votre niveau d’exercice recommandé. NE PAS s’entraîner jusqu’à l’épuisement. Avant de commencer un programme d’exercice, vous devriez consulter votre médecin.